JWP8152 - Defender Left Hand Front Outer and Top Wing with Nose Panel - Fits from 1983-1994 - Pre-Bolted Together

This is a direct replacement for all 1983-1994 Defender models. This has the air intake hole, if you need one without the intake hole you need part number JWP8150. Normally the type with air vent hole was used on 2.5Td and 200tdi models.
Has no side repeater hole so you will need to drill the 3 small holes for this yourself. Or leave blank if you have no side repeater.

The front part of the wing on this wing is of the later and better 94-16 spec where the sidelight and indicator lights screw into plastic nut inserts rather than straight into the aluminium as per pre 1994 models. So when fitting you will just need per wing: 4x plastic nut inserts part numbers 79051 and the longer self taping screws which are part number DA1168 (This kit actually has enough screws to do the full vehicle).
Everything else just swaps straight over.

These are never available as complete units like this as you can only get the parts seperately which requires yourself to bolt the side panel to the top and front panel which can be a bit time consuming and fiddly to get right.

However we supply this all bolted together so it is literally just a simple bolt on job to your vehicle

This is made from aluminium as original and comes finished in a black powercoat so with a light flat down with fine sandpaper, say a 1200 grit, is ready to go over with your paint

 

Ideal to replace those dented and damaged wings on your Defender.

Often the wing top becomes dished in which can look unsightly and is near impossible to fill as once the panel has dished downwards, it never seems to want to spring back up!

 

So replacing it with a brand new wing like this will bring your Defender back to factory spec! You can of course still fit wing top chequer plate if you wish