DA3494 | GL1045 - 33mm Ball Joint Boot Clip in Stainless Steel - Comes as a Single Unit - By Gwyn Lewis 4x4 - For Multiple Uses on Land Rover and Range Rover Vehicles

Fits:-
Land Rover Defender, Land Rover Series 3, Discovery1, Discovery 2, RRc and P38.
Defender Drop Arm Ball Joint.
Our HD Greaseable Track Rod Ends.
Original Lemforder Track Rod Ends.
Delphi Track Rod Ends.
Defender Anti Roll Bar Link Arms.

Internal Diameter:- 33mm

These are replacement Track Rod End Boot Clips made out of 302S26 Stainless Steel spring wire, designed to hold the boot onto the ball joint.

These clips are the ideal clips to use with our Polyurethane Ball Joint Boots GL1173

We also supply the Polyurethane Boots if required, GL1173
A common problem with Rubber Track Rod End Boots these days is perishing/cracking, Rubber doesn’t seem to be what it used to be.
Polyurethane boots will not perish/crack like normal Rubber so will give a much longer service life.

We would recommend that you do not fit the smaller clip that your original Rubber Boot may be fitted with, leaving this clip off will allow old grease to squeeze out as new grease is pumped in, it will also stop the Boot swelling and popping off from over greasing.
Also, the Boot needs to swivel over the track rod end shaft as your steering is turned lock to lock, so even if your track rod end is not a greasable type this will help stop the boot from twisting as the shaft turns with your steering.