GL1075 - Gwyn Lewis Rear Heavy Duty, Cranked Radius Arms - Comes as a Pair Uncoated - For Defender, Discovery 1 and Range Rover Classic

These are our DIY rear arms, they are fully welded and have the rear bush pressed into them, all you need to do is rub them down and paint them.

The blue ones in the pictures are for reference only, these arms are identical to the blue ones, but haven’t been coated.  

They are a must have for any Land Rover that is used off road, as the standard arms are just not strong enough to cope with all the axle and suspension twisting, these are probably the strongest rear arms you can get at 12.5KG a pair, using 43mm x 5mm wall tube on the outside and 28mm x 3.5mm wall on the inside.

They are twin wall, 43mm O/D heavy duty 5mm steel tube and have a cranked end to improve articulation, they come complete with the bush in the axle end and a new nut on the chassis end, the axle end is offset welded to stop the arm fouling the axle mounting on full suspension dropout, suitable for standard to 4 inch suspension lifts.

On older RRc you will require a chassis bush as the older ones had imperial threads and the bush has a smaller hole in it. If you are unsure the older ones have a 24mm nut on the chassis end, ours are metric M20 thread and a 30mm spanner fits the nut on the chassis end. Most rear arms are metric.